One of the current challenges in physics-based ground-motion simulations is to refine the modeling of local site effects. These effects require a finer spatial resolution in the material modeling than that generally considered in regional-scale simulations. Because of this, empirical amplification factors are typically applied to capture these unmodeled phenomena. The ergodic nature of this approach suggests that there is room for improvement. In this study, the predictive capability of simulations is evaluated using alternative methods for capturing local site effects. In addition to the conventional empirical approach, two methods are examined that allow for more site-specific information to be incorporated: the square-root impedance method and the 1D time domain site-response analysis. The three approaches are tested using 1000+ observed ground motions from 150+ small-magnitude events (3.5 ≤ Mw ≤ 5.0), recorded at 20 strong-motion stationsin the Canterbury, New Zealand, region. These 20 well-characterized sites represent a wide range of soil conditions, including stiff gravels with Vs30 values greater than 500 m/s, and sand and silt deposits with Vs30 valuesless than 200 m/s. Multiple intensity measures are computed and prediction residuals are partitioned using mixed-effects regression to rigorously assess the relative performance of the different approaches considered. The results indicate that the benefit of using more sophisticated methods is highly dependent on the characteristics of the site. Key site parameters and trends are identified and discussed in light of the assumptions and limitations of each approach.
This paper provides a summary of initial research results investigating systematic site effects from the prediction residuals of empirical- and physics-based ground-motion models (GMMs) for small magnitude (i.e., 3.5 ≤ MW ≤ 5) active shallow crustal earthquakes in New Zealand (NZ). Advancing ground-motion predictability through physics-based GMMs is an iterative process and requires addressing fundamental questions like: Is there salient physics which has been overlooked? Which geographic regions have predictions that significantly deviate from observations and why? Which sites exhibit systematic prediction residuals and how can the attributes influencing them be identified? This preliminary study examines these questions by classifying 171 sites from the Canterbury and Wellington regions into four geomorphic categories: basin, basin-edge, hill, and valley, following the categorisation by Nweke et al. (2022). Trends in the site-to-site residuals for each geomorphic category indicate apparent differences between the four categories, with residuals for valley sites illustrating a clear dependence with the inferred fundamental site period. Computed residuals from both empirical- and physics-based GMMs also provided insight into the role of site-specific attributes vs. the different prediction methods, assisting to understand the salient causes of these residuals.
The Mѡ=7.1 Darfield (Canterbury) earthquake struck on 4 September 2010, approximately 45 km west of Christchurch, New Zealand. It revealed a previously unknown fault (the Greendale fault) and caused billions of dollars of damage due to high peak ground velocities and extensive liquefaction. It also triggered the Mw=6.3 Christchurch earthquake on 22 February 2011, which caused further damage and the loss of 185 lives. The objective of this research was to determine the relationship between stress and seismic properties in a seismically active region using manually-picked P and S wave arrival times from the aftershock sequence between 8 September 2010-13 January 2011 to estimate shear-wave splitting (SWS) parameters, VP =VS-ratios, anisotropy (delay-time tomography), focal mechanisms, and tectonic stress on the Canterbury plains. The maximum horizontal stress direction was highly consistent in the plains, with an average value of SHmax=116 18 . However, the estimates showed variation in SHmax near the fault, with one estimate rotating by as much as 30° counter-clockwise. This suggests heterogeneity of stress at the fault, though the cause remains unclear. Orientations of the principal stresses predominantly indicate a strike-slip regime, but there are possible thrust regimes to the west and north/east of the fault. The SWS fast directions (ø) on the plains show alignment with SHmax at the majority of stations, indicating stress controlled anisotropy. However, structural effects appear more dominant in the neighbouring regions of the Southern Alps and Banks Peninsula.
We examined the stratigraphy of alluvial fans formed at the steep range front of the Southern Alps at Te Taho, on the north bank of the Whataroa River in central West Coast, South Island, New Zealand. The range front coincides with the Alpine Fault, an Australian-Pacific plate boundary fault, which produces regular earthquakes. Our study of range front fans revealed aggradation at 100- to 300-year intervals. Radiocarbon ages and soil residence times (SRTs) estimated by a quantitative profile development index allowed us to elucidate the characteristics of four episodes of aggradation since 1000 CE. We postulate a repeating mode of fan behaviour (fan response cycle [FRC]) linked to earthquake cycles via earthquake-triggered landslides. FRCs are characterised by short response time (aggradation followed by incision) and a long phase when channels are entrenched and fan surfaces are stable (persistence time). Currently, the Te Taho and Whataroa River fans are in the latter phase. The four episodes of fan building we determined from an OxCal sequence model correlate to Alpine Fault earthquakes (or other subsidiary events) and support prior landscape evolution studies indicating ≥M7.5 earthquakes as the main driver of episodic sedimentation. Our findings are consistent with other historic non-earthquake events on the West Coast but indicate faster responses than other earthquake sites in New Zealand and elsewhere where rainfall and stream gradients (the basis for stream power) are lower. Judging from the thickness of fan deposits and the short response times, we conclude that pastoral farming (current land-use) on the fans and probably across much of the Whataroa River fan would be impossible for several decades after a major earthquake. The sustainability of regional tourism and agriculture is at risk, more so because of the vulnerability of the single through road in the region (State Highway 6).
